K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre 607 Ballistic Coefficient G7 0

607 Ballistic Coefficient G7 0

A pivoting bipod will allow the shooter to compensate for ground that is not level by up to 20 degrees

243 Bullet Weight 95gr Bullet Style VLD Hunting Boat Tail Ballistic Coefficient G1 0

yet controlled expansion

The tube bottoms against the flat surface of the primer housing in the Co-Ax Primer Seater

K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre 607 Ballistic Coefficient G7 0This finely ground carbide cutting pilot, designed for use with the K+M case neck turning body, has four cutting flutes used to remove the doughnut that can form at the inside neck wall and shoulder junction. If you are noticing the formation of a doughnut, this tool will remove the excess material without affecting inside neck diameter allowing for uniform bullet seating and eliminate powder gas restriction. There is also less friction between brass